How to configure a BacNET-Device via WAGO-Controller?

First of all the service called “BACstac Protocol” must be started get the tool working, in case it is not set to start automatically.
Afterwards you can add and modify BACnet Objects using the WAGO-Controller to check your test environment. If you don’t get any connection to your BACnet-Device, be sure that you are using only a single network connection, and that your Controller is active.
While you are configuring your BACnet Objects, be sure that there is no running process named “bacnet.exe”, this would cause internal conflicts. After you have finished configuring your Devices, don’t forget to stop the “BACstac Protocol” again, before you start your WinCC OA project.