Pipe

With a pipe you can construct pipe layouts in a 3D presentation including T and cross connectors.

Available functions Description
"armed" Indicates whether or not a button is pressed.
"connectorBeginRef" Defines the beginning / starting point of a reference or reads it.
"connectorConnectionType" Sets the Connector Type
"connectorEndRef" Defines the end/ end point of a reference or reads it.
"flowFillPercent" Defines the percentage of the whole pipewidth that should be used for the flow effect within a pipe.
"flowing" Defines the flowing speed and the flow direction of the flowing effect within a pipe.
"points" Sets or gets the vertices of a polygon side or pipe.
"positionOnPath" Describes any position on a pipe side.
"width" Specifies the width of a pipe.